|
Model
DS150
Dual
Probe,
Double
Metal Sheet Detector
Features:
•Push-button
calibration, instantaneously sets reject
threshold and adjusts signal for type and
thickness of metal detected.
•Multi-gauge
double detection without calibration changes.
•Thickness
Detection range of .05 mm to 8 mm (.002”
to .300”) provides flexibility for a broad
range of thickness applications and metals.
•Diagnostic
warning is provided through various indicator
flash patterns for error and probe failure.
•Power
Input is user configured to 120 Volts AC
or 240 Volts AC @ 50-60 Hz.
•Wide
trans./rec. probe separation to 75 mm (3”)
when used with P70CS on light gauge steel.
•Quick
connect terminals for fast replacement,
and to reducing downtime.
•Contact
relay output to interface with most input
or control circuits, contacts rated at 10
AMPS (½ HP) @ 240 Vac, 8 AMPS @24 VDC.
Metal
blanks that are free to bounce or move vertically
as much as 75 mm (3 inches) in a conveying
system are easily monitored by Prime's Model
DS150. It senses many different metals by
using separate transmitter and receiver
probes that can detect metal within a 3”
(75 mm) range. It inspects over a thickness
range of 002” to .320, (.05 mm to 8
mm). Calibration is completed by pressing
a push-button located on the front cover
with a nominal and double sample. It immediately
senses several conditions and sets the double
reject threshold. If it detects any system
failures, while operating, it begins flashing
one of its indicators and switches its output
to reject. The DS150 is an excellent detector
for steel, aluminum, tinplate, thick *stainless
steel, copper, brass and many other metals.
*
thin stainless, copper and aluminum film
may require a Model
DS3410
|
