Can and End Leak Transducer

Features:

• Lower cost than original
• Precise leak pressure measurements
• Performs the same function as the original TD5
• Values are displayed in absolute psi or mbar
• Data collect port with profiling software
• TD5P mates to the same air port as the older TD5
• Inputs to all types of Pressure Amplifiers, PS1,PS2,PS6,PS8, PS10, PS12 and PS16 and MD20.

Prime Controls' TD5P is a direct replacement for the original TD5 found on all Borden, Alcoa, Randolph and Somec Can and End Testers

Quick Installation: This transducer easily replaces the old TD5. Simply unscrew the TD5 and replace it with the TD5P. Reconnect the original cable. That is all there is to it. Proceed with the standard calibration of the Pressure Amplifier as you would with the original transducer. All specifications are the same. Primes TD5P meets ROHS standards. For further details refer to the specification sheet.

The TD5P Transducer is used by canmakers to measure the leaks in newly manufactured food, beverage and aerosol cans. Other tested products are can ends, oil filters and low profile fish cans,. Prime's Model TD5P will detect micro-leaks and withstand extreme over pressures. If there is a need to sense a 2 cc leaker or greater, the TD5P is guaranteed to detect it.

It is ROHS compliant and a lower cost alternative. It is a rugged sensor you can depend on for accurate and reliable leak detection. Prime Controls offers a money back guarantee if it does not perform to expectations.

Call Prime Controls for complete information or e-mail us at vip@primecontrols.com